Whirlpool EKA 3483 IN LI Manuale di Installazione Scaricare il pdf (Pagina 2)

2. Sealing the glass ceramic hob

Seal the space around the glass using black silicone,

avoiding air bulbs. Gently remove any excess

silicone.

Spray a mild solution of water and liquid soap all

around the silicone beading.

Using a hard rubber or plastic spatula, spread the

silicone beading evenly, then remove the excess

silicone, cleaning and wetting the spatula now and

again with the soapy solution.

The glass surface and worktop must be level and

free of any silicone residue. If necessary, use a wet

finger to level out the silicone surface.

The mastic and silicone will take approximately 24

hours to set and reach full strength and elasticity.

During this period, the glass ceramic hob should not

be used, nor should it be subject to mechanical

stress.

Attention:

Before sealing special materials (stone,

etc.), make sure the material in question is

compatible with the primer and the mastic.

Attention: If the above recommendations are

not followed, after a certain period of time,

water and other liquids may penetrate the

worktop, causing swelling at the edges that

may result in damage to your glass ceramic

hob.

Note:

In the event the hob is fitted into a stone worktop,

request technical advice from your supplier or carry

out a test of the cleaning agents to be used, as well

as the primer and silicone.

Such tests should be carried on unseen areas or on

samples.

41966024aGB.fm Page 4 Friday, February 25, 2005 5:18 PM

1 2

Nessun commento

Whirlpool EKA 3483 IN LI Manuale di Installazione Pagina 2