Whirlpool PI 941 AS (IX) Istruzioni per l'uso Scaricare il pdf (Pagina 13)

cm²) so the inside of the furniture unit is adequately

aerated (see picture).

Furthermore, a wooden board A must be placed

beneath the hob for heat insulation. It must be at

least 15 mm from the hob casing (see picture).

Fitting the hob to the worktop

The hob must be fitted to the worktop in the

following manner:

 Mount the provided clamps B and partially

tighten the screws A in the relative holes.

 Place the provided sealing gasket X 5-6 mm

from the cut-out edge,

ensuring the ends of the seal

meet without overlapping.

 Fit the hob into the cut-out,

centre it and ensure the hob

edge adheres to the seal.

 Place the clamps B

correctly and then tightly

fasten the screws A.

Electrical connections

Hobs equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate (located on the underside of the hob).

The earth wire in the cable has

a green and yellow covering.

If the hob is to be fitted above

a built-in electric oven, the

hob and oven electrical

connections must be carried

out separately, both for

electrical safety purposes and

to facilitate oven extraction.

Connecting the electricity supply cable to the

mains

Mount a normalised plug corresponding to the load

indicated on the data plate.

When connecting the appliance directly to the

mains, an omnipolar switch with a minimum contact

opening of 3 mm must be installed between the

appliance and the mains. The switch should be

sized for the required load and must comply with

current electrical regulations (the earth wire must not

be interrupted by the switch). The supply cable

must be properly positioned to avoid reaching more

than 50°C above room temperature, at any point

along its length.

 The installer is held responsible for the correct

electrical connection and for the observance of

safety regulations.

Before connecting the appliance to the power

supply, ensure that

 The appliance is earthed and the plug complies with

regulations.

 The socket can withstand the maximum power of

the appliance, which is indicated on the data

plate.

 The voltage falls between the values indicated on

the data plate.

 The socket is compatible with the appliance plug.

If not, the socket or plug must be replaced; do

not use extension cords or multiple sockets.

 Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

 The cable must not be subject to bending or

compression.

 The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

 The manufacturer declines any liability should

these safety measures not be observed.

Gas connections

The appliance must be connected to the main gas

supply or to a gas cylinder in compliance with

current national regulations. Before carrying out the

connection, make sure the hob is compatible with

the gas supply you wish to use. If this is not the

case, follow the instructions indicated in the

paragraph Adapting to different types of gas.

When using liquid gas from a cylinder, install a

pressure regulator that complies with current national

regulations.

 Check that the pressure of the gas supply is

consistent with the values indicated in Table 1

(Burner and nozzle specifications). This will ensure

the safe operation and longevity of your appliance

while maintaining efficient energy consumption.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Commenti su questo manuale

Nessun commento

Whirlpool PI 941 AS (IX) Istruzioni per l'uso Pagina 13

Commenti su questo manuale

Prodotti e manuali riguardandi Piani cottura Whirlpool PI 941 AS (IX)