EN 17
• For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the gure.
• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
• Cut the worktop to t before installing the hob and carefully remove any shavings or sawdust.
• If an oven is installed beneath the hob, make sure that it is equipped with a cooling system.
• In the case of ush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.
• To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.
• Do not install the hob above a dishwasher or washing machine, to prevent the electronic circuits from coming into contact with steam or moisture and being
damaged as a result.
ELECTRICAL CONNECTION
• Disconnect the appliance from the mains power supply.
• The appliance must be installed by a qualied technician who is fully aware of current safety and installation
regulations.
• The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from
failure to observe the regulations provided in this chapter.
• The power supply cable must be long enough to allow the hob to be removed from the worktop.
• Make sure the voltage specied on the appliance rating plate is the same as that of the domestic power supply
voltage.
• Do not use extension cables.
Connecting to the terminal board
For electrical connection, use an H05RR-F cable as specied in the table below.
Number x size
230V ~ +
3 x 4 mm
2
230-240V ~ +
3 x 4 mm
2
(Australia only)
230V 3 ~ +
4 x 1,5 mm
2
400V 3N ~ +
5 x 1,5 mm
2
400V 2N ~ +
4 x 1,5 mm
2
Wires
400 V 3N ~230 V ~
230-240 V ~ (Australia only)
230V ~ (UK only)
400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only)
230V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
CBA
Connect the yellow/green earth wire to the terminal with the symbol .
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw it on the terminal block with the removed screw - point (1).
Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds.
If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means
of an all-pole disconnect switch with minimum contact gap of 3 mm.
(10 pagine)
(24 pagine)
(40 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale